Intel Board SE7221BA1-E Signal “Out of Range” with fresh Windows 2003 Install
Posted By Chris in Hardware, Windows
With a fresh install of Windows 2003 on the Intel SE7221BA1-E server board, no default graphics driver is loaded. This causes an “out of range” message to appear on most monitors after the LOAD screen finishes, when the logon screen is supposed to appear.
The solution is to press F8 when the server loads up and either enter SAFE MODE or VGA MODE.
Then install the Intel Chipset drivers found here and the Intel Graphics drivers found here.
Related posts:
- Enabling Internet on fresh Windows Server 2008 install
- How to install PHP ISAPI on Windows 2008 IIS7 x64
- Slimming down Windows XP Pro SP2 Install
- How to Install Windows Server 2003 R2 enhancements on Windows Server 2003 SP1
- DOS Windows only Half Screen in Windows XP
| 
Print This Post
|
Is this gonna end someday??
Nope. There are no fixes being developed. Support for the board is now over.
Hello Everybody
Just wanted to share my new experience.
If your Windows XP denies to start due to an error related to lost HAL.DLL, invalid Boot.ini or any other critical system boot files you can repair this by using the XP installation CD. Just boot from your XP Setup CD and enter the Recovery Console. Then launch “attrib -H -R -S” on the C:\Boot.ini file and remove it. Run “Bootcfg /Rebuild” and then Fixboot
Cheers,
Carl
i have found this also with the VGA device on motherborad MSI 945GM3 v1.0. will try solution now, as safe mode does work